A Topside company - serving San Marcos, TX

Before & After Gallery - Topside Attic Insulation San Marcos

Insulation Before & After in San Marcos, TX

We’ve documented every job we’ve done since 2016. The photos below show what we found, what we fixed, and how we proved it worked. No stock images, no renderings. Just attics and crawl spaces in San Marcos, Kyle, Buda, and the rest of Hays County, with blower-door numbers to back up the pictures.

Call (737) 337-8049

Recent Transformations

Attic Insulation Removal and Replacement - Old Batting, New Blown-In

Before and after attic insulation removal and replacement in San Marcos home
Left: original R-19 fiberglass batting compressed to under R-10. Right: new blown-in cellulose at R-38, with sealed top plates and can-light enclosures visible.

This 1987 home off Hopkins Street had original fiberglass batting that had compressed, shifted, and collected fourteen years of dust and rodent evidence. We removed the old material, sealed every top plate and penetration with foam, then blew in GreenFiber cellulose to R-38. The blower-door test read 3,800 CFM50 before we started and 2,100 after - a 45% reduction in conditioned air loss. The homeowner got the photo record, the written scope, and the before-and-after numbers on paper before we packed up.

Crawl Space Encapsulation - Dirt Floor to Sealed Envelope

Before and after crawl space encapsulation with vapor barrier in San Marcos area home
Left: exposed dirt crawl space with standing water after rain. Right: complete encapsulation with 12-mil vapor barrier, sealed seams, and dehumidifier drain line.

A ranch-style house near the San Marcos River had a crawl space that stayed damp year-round, with fiberglass batting falling from the joists and mold spotting the subfloor. We pulled the degraded material, installed a 12-mil reinforced vapor barrier with sealed seams and mechanical fastening, and ran a dehumidifier drain to daylight. The relative humidity dropped from 78% to 52% within 72 hours. We documented the moisture readings and the sealed barrier with photos at every stage.

Spray Foam Insulation - Open-Cell in a 1950s Pier-and-Beam

Before and after spray foam insulation in pier and beam home near San Marcos
Left: uninsulated floor joists with visible gaps to exterior. Right: open-cell spray foam at 3 inches, filling cavities and air-sealing in one pass.

This house in the Blanco Gardens area had never had floor insulation. The hardwood floors were cold in January, and the gas bill ran high enough that the owner called us for a home energy audit first. We recommended open-cell spray foam at 3 inches in the joist bays, which gives roughly R-13 plus full air sealing. The install took one day. The blower-door number moved from 4,200 CFM50 to 2,600 - meaningful in a house with this much leakage through the floor. The owner now has the photo record and the written warranty under our 365-Day Done Right Promise.

Radiant Barrier Installation - Unshaded Roof, 140°F Attic

Before and after radiant barrier installation in San Marcos home with unshaded roof
Left: dark shingle roof deck with no reflective barrier, attic temperature 142°F in August. Right: perforated radiant barrier stapled to rafters, attic temperature 108°F same time of day, one week later.

A two-story home in the Willow Creek subdivision had a south-facing, unshaded roof and an attic that hit 142°F by 2 PM in August. The upstairs AC ran continuously and still couldn’t keep up. We installed a perforated radiant barrier to the underside of the rafters, which reflects radiant heat rather than absorbing it. The attic temperature dropped to 108°F at the same time of day, one week post-install. We measured both readings with the same infrared thermometer, documented the rafter spacing and staple pattern, and included the photos in the job record. This is not a replacement for insulation, but in a San Marcos summer, it changes how the attic behaves.

Attic Air Sealing Before Blown-In - The Haven Standard Sequence

Before and after attic air sealing with blower door test results in San Marcos home
Left: unsealed can lights, plumbing penetrations, and top plates visible in attic floor. Right: same locations after foam sealing, with blower-door reduction from 3,400 to 1,900 CFM50.

We won’t blow insulation over an unsealed attic floor. This house in the Sagewood neighborhood is why. The previous contractor had added blown-in fiberglass over wide gaps at the top plates and unenclosed can lights. We pulled it back, sealed every penetration with expanding foam and rigid boxes where needed, then replaced the insulation with new blown-in at proper depth. The blower-door test dropped from 3,400 to 1,900 CFM50 - the air sealing did more than the insulation replacement. The homeowner got both numbers in writing, plus photos of every sealed location.

Insulation Removal After Rodent Activity - Cleaning, Sealing, Replacing

Before and after attic cleaning and insulation replacement following rodent proofing in San Marcos area home
Left: contaminated fiberglass batting with rodent trails and compressed tunnels. Right: sanitized decking, sealed entry points, new blown-in cellulose at R-38.

A home near the edge of Spring Lake Natural Area had attic insulation that rodents had used as nesting material for multiple seasons. The batting was compressed, stained, and tunneled through. We removed it, HEPA-vacuumed the decking, sanitized with an enzyme treatment, sealed every potential entry point with steel mesh and foam, then installed new blown-in cellulose. The photo record shows the entry locations before sealing, the mesh in place, and the finished depth markers. No guesswork, no “trust us on this one.” The Haven Standard requires documentation, and this job generated 47 images.

Want Results Like These?

professional installing fiberglass attic insulation between wooden joists
Want Results Like These?

We’ve sealed and insulated over 9,000 homes since 2016, and every one started with a written price before any work started. Call (737) 337-8049 - a live person answers, 24/7. We’ll schedule a free estimate, review your existing insulation if you have any, and give you a flat price with a written scope and warranty before anyone lifts a tool. Bring us a competing quote; we’ll read it with you. Under Haven Standard Clause 1, the price you see is the price you pay.

Written by Wes Okafor, Owner at Topside Attic Insulation San Marcos, serving San Marcos, Kyle, Buda, and Hays County since 2016.

Need Insulation help in San Marcos? Licensed & insured · 60-minute response · free estimates
Call (737) 337-8049
Local Service Coverage

Request a Free Estimate in San Marcos

Tell us what you need - Topside Attic Insulation San Marcos responds fast. No obligation.

When you send us your details, you acknowledge our Privacy Policy and authorize us to contact you by phone, text, or email regarding your project, including by the service partners who may complete the work.

Prefer to text? Text Now
Call Now - 24/7 Dispatch